Replacing the Micro scooter quick acting clamp is very easy.

INSTRUCTIONS:

How do I replace the quick release clamp on my scooter?

• Open the clamp and tighten the ribbed knob as tight as possible
• Remove the retaining ring (note, it can jump out, so preferably on a clean, smooth floor)
• Now unscrew the ribbed knob completely
• Pull out the clamp on the other side
• Install the new clamp in reverse order
• After the locking ring has been replaced, adjust the tension on the S-clamp by turning the ribbed knob. The clamp should close with some resistance.

See also the instructional video on this page.